3592 70F Tape Drive Code Fixlist:


===================================================================================================

Drive Code Level: 70F_52A  (70F_FH_FC)
Fixes:
===================================================================================================

Added unique MIM for EOL media (TS77xx specific)
Fix drive reset that occurs at  partition change
Fix Load/Unload handling after checking CM fails
Modify calib/rechuck handling in write filter
Fix 2C30 (write protect) with uninitialized WORM
Fix Write failure (FSC 5023)
Fix skew coil protection logic that caused FSC 2E12 on load
Resolve very small SRR race where FC interface may hang
FC REC Task Retry Identifier checked when not supported.
Fix drive panic with FSC 4000 on writing data after locating to FastSync segment
Fix drive panic during ERP
ERP improvements
Fix FSC 7853 error after rewind
Fix case where CM EOD info is updated with wrong information
Fix drive panic during ERP calib
The ending geometry information in RAO may be incorrect for short UDSes.
Adjustment to tape transport control
RAO estimates and ordering may be slightly degraded
Fix drive panic FSC4000:D100
LTO10 has changes to Tape Map servo logging fields
Fix Read ahead limit DS number calculation
Add TDS Calibration version in use by the Firmware
HRTD HKDS is generated unexpectedly when ERP is executed at EOW
Fix cleaning failure (FSC 8E17)
Fix eHKDS write failure (FSC 5551)
Fix drive reset during Fast Sync writing





===================================================================================================

Drive Code Level: 70F_495  (70F_FH_FC)
Fixes:
===================================================================================================

WRITE_ATTRIBUTE 1010h hangs if WTC bit is set
Fix FSC 4354 for locate command during writing data
Fix read error during ERP
Fix panic during writing on ABF wrap
Populate the Log page 3Eh HRTD HKDS counters
Fix panic during ERP
Fix FSC 401D case
Improve lateral position recovery
Add write fence condition with no TDS settings
Improve load time
Fix Read failure case
Improve Long erase command on TS1170
Fix read failure due to invalid partition number
FC fast reuse of OXID after CONF may cause implicit logout
Fix rewind timeout
EPR improvement
Improve fibre channel error recovery of performance path sense data
Prevent write append error (fsc4720) from setting Customer Perm Error Data Read 
Fix Append failure case
Fix servo error after ERP
ERP improvement
Fix fead command timeout error case
Eliminate extra tape motion
Prevent unecessary drive backhitch
Fix write command timeout during Fast Sync