IBM HBA/LSI Onboard 6Gb SAS/SATA/SSD Driver for Red Hat 
    Enterprise Linux 5

Supported Controllers:  IBM 300GB High IOPS MLC Modular Adapter (90Y4361)
			IBM 800GB High IOPS MLC Modular Adapter (90Y4369)
			IBM 300GB High IOPS SLC Modular Adapter (90Y4373)
			IBM 600GB High IOPS MLC Modular Adapter (90Y4365)
			ServeRAID H1110 SAS/SATA Controller for IBM System x (81Y4492)
                        IBM 6Gb SAS HBA (46M0907)
                        IBM 6Gb SSD HBA (68Y7362)
                        Onboard LSI 2004 SAS

Supported Kernesl:  RHEL 5.8 	2.6.18-308 
		    RHEL 5.7 	2.6.18-274 
		    RHEL 5.6 	2.6.18-238

NOTE TO SERVICE - Reference RETAIN N/A

Version 15.00.00.00 - Suggested
------------------
Enhancements:
 - Add support for RHEL 5.7 and 5.8
 - Add support for 300GB MLC (90Y4361), 600GB MLC (90Y4365), 800GB MLC (90Y4369) and
   300GB SLC (90Y4373)

Version 10.30.00.00 - Suggested
------------------
Fixes:
 - Use a different method for blocking IO request from SCSI Mid Layer when
   using the SysFS shost attribute called task_management.
 - Fixed issue to not allow IOCTLS to be processed when tge device driver
   is loading, which could cause a kernel panic.
 - Added support in asynchronous scanning logic to handle faults during
   discovery when loading the driver.
 - Allocate only one msix vector for the controllers that do not support
   multi-reply queues and NUMA IO.
 - Added per lun delete flag to addres an issue where a cable is removed and
   added back within the DMD timer expired timeout.
 - Fixed issue with reading raid configuration information for inactive volumes
 - Fixed issue where a Stack trace seen in message log after cable pull and
   host reset.
 - Fixed issue where The configuration pages are failing if raid volume is
   configured while issuing a host reset
 - Fixed issue where the Devices are not removed after "cable pull".
 - Fixed issue when devices are behind two deep cascaded expanders, they
   don't get added if the "cable add" is done while host reset is active.
 - Fixed a failure message displayed in the log messages during host reset
   while removing devices
 - Fixed issue where drives are not getting removed when the enclosure cable
   is pulled out from the expander and Port Reset is issued.
 - Fixed issue where the Chip Resets results in repeated timeouts.
 - Fixed issue with expanders where a hang occurs when there is smart error.

Version 4.30.01.00 -  Initial release
------------------